|
roaming | Right. You will have a Right Offset and a Forward Offset to enter, for each section. I'm assuming your NH3 bar is a single section.
Your Right Offset is measured from the centerline of the GPS receiver to the LEFT edge of the section, which in this case is the left edge of the NH3 applicator bar.
Your Forward Offset is measured from the center of the GPS receiver (if your GPS Forward Offset is 0" in Toolbox > GPS), or the center of the rear axle (Magnum-style tractor) or center of the front axle (articulated tractor) if you have a non-zero GPS Forward Offset. You measure to the application point (NH3 knife) on the implement. | |
|
CaseIH pro 600 implement measurements
