AgTalk Home
AgTalk Home
Search Forums | Classifieds (107) | Skins | Language
You are logged in as a guest. ( logon | register )

Will a DCM-300 work on a Trimble 252
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
IH1486
Posted 2/26/2012 01:36 (#2252034 - in reply to #2251992)
Subject: Re: Will a DCM-300 work on a Trimble 252


Minnesota
If you don't mind me asking, what setup do you currently have? There is alot of new options coming from CNH, if you are already vested in CNH or Trimble products it might be wise to hold off on purchasing another manufacturer. With the new 372 receiver GLONASS is an optional unlock, will still be able to use anything from WAAS(SBAS) to RTK, to RTK GLONASS. If you are not looking to do land leveling or putting in tile, the 372 will support RTX which is advertised at 1.5" repeatable accuracy. With Standard convergence you only need to unlock the receiver to OmniStar, and will see a convergence time of 20-25 minutes most of the time, same as using an Omni XP/HP signal. There is also the option for RTX Fast convergence, where your receiver will lock on to the DGPS signal within just a few minutes, but that requires you to unlock the receiver to RTK, and is only available in certain areas. There are also alot of changes for compatiblity on section and rate control options on different implements. Food for thought.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)