AgTalk Home
AgTalk Home
Search Forums | Classifieds (100) | Skins | Language
You are logged in as a guest. ( logon | register )

GS2 2600 in JD8520T & Original Display in JD7930
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Dennis SEND
Posted 2/25/2012 19:40 (#2251410 - in reply to #2251395)
Subject: Re: GS2 2600 in JD8520T & Original Display in JD7930



In order to put the 2600 in the 8520T you will most likely need a jumper wiring harness that plugs into both the ends and converts it to the new style plug like on a 2600(depends on if the wiring harness was factory installed or added on later as some of the later field install kits also used a bulkhead plug like your 7930 has) if that is the case just use your existing harness from the 7930, to put the brown box into your 7930 you will need a harness to go from the corner bulkhead to the display/mobile processor if you are not using a mobile processor you may be able to get by with the current harness that is feeding the 2600 cause that harness also has a single plug for the orginal display along with the plug for a GS2.

Part # for the harness are

Bulkhead to GS2 is PF80793
Bulkhead to orginal display/mobile processor is PF80818

I don't know the part number for the harness that would plug into the factory wiring harness ends on a 20 series tractor to convert it to GS2 plug

Edited by Dennis SEND 2/25/2012 19:47
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)