|
IL | I am working on an old disc for a project and the hitch pivot ( where the fore and aft pitch is adjusted) is very sloppily worn. When I tried to pull a little faster and it hit a bump, it wanted to dance side to side.
The long pin thru it worn, as well as the holes. How can I tighten up?
My drill press does not run slow enough for an oversize bit to put a bigger pin in. And my fill in a reem skills are less than great.
All ideas appreciated
Edited by west illini 2/23/2012 20:01
(disc hitch.jpg)
Attachments ---------------- disc hitch.jpg (37KB - 29 downloads)
| |
|