|
| I agree with the above, but you should also look at upgrading the Nav II to V5.20, which has a fix for intermittant End of Row Warning failure on MT CAN Based machines. I had 3 MT800's which couldn't get the End of Row Warning working at all. 2 had Ez-Guide 500's and the other had an FMX on V6.0. V5.20 fixed this EOR issue on all of them.
Also check the Hydraulic Lock-Out switch on your MT - I think this will also block CAN messages and bring up this 118 fault as well. | |
|
Trimble autopilot fault 118
