|
Minnesota | You are able to get mapping in the Intelliview IV and you can use it for rate control/changing rates. You are also able to do variable rate presciptions through the Intelliview IV. Section control is not supported via the serial connector so you will still need to turn the booms off manually.
As to your question on setting up boom sections, (looking at the machine from behind), you will always measure from the center of the machine to the left edge of the boom section, would be where the product covers ground, not end nozzle. For sections that start left of center you will enter a negative number, for sections right of center you will enter a positive number.
Edited by IH1486 2/7/2012 16:51
| |
|
raven 450 with intelliview 4
