|
| That's the best way , do that with each one , depending on how close you want to be , but especially a nitrate blend , IF you use nitrate , also different prill sizes with flow out different. Which is why a nitrate constant is important , it's like little ball bearings , if using a urea constant , we cut the rate back by about 20% . But I hate guessing.
There's also a formula you can use , recommended by raven, spread a load see how much it's off , enter the difference in formula , get new constant , repeat until it's correct.
SCREWED up way if you ask me. % ( | |
|
HOW do they even sell the things ? ? ? ? ?
