| I've got a Hypertherm 45 also and run a dual setup for moisture removal. Run inlet air through a Sharpe water separator and air regulator and then into the motor guard moisture filter, then up to the plasma cutter where there is a built in air regulator. Works very well on different thicknesses only need to slow down on really thick material cutting.
 (P1010139 (Medium).JPG)
 (P1010140 (Medium).JPG)
Attachments
----------------
 P1010139 (Medium).JPG (79KB - 419 downloads)
P1010140 (Medium).JPG (55KB - 407 downloads)
|
Hypertherm Plasma ????
