|
| There are new software releases, current is version 1.7 is out now. Your local cnh/trimble dealer should have it.
In the display you can save configuration's,from main menu, go to system, advanced, then save/load configurations. Then you can save your tractor/implement and your combine or whatever else you may need and reload a configuration when needed. If you make any geometry changes or change any other settings for the configuration you are using make sure to re save your changes. If you have autopilot I am not sure if the profile in Nav. II controller will change when you change your configurations in the display. Some of the other guys on here may be able to help answer that. If you don't have autopilot disregard the above statment.
hope this helps | |
|