|
Chokio, MN | Here is a release note just follow the one that says what to do for the NAV II and it will also depend on what monitor you are using on the Trimble side. But here are the NMEA outputs that you need to enter to allow the GS2 monitor to recieve the GPS: GGA-on; GSA-on; RMC-on; baud rate needs to be set at 19200; data bits-8; Parity-none; Stop Bit-1; Flow Control-none; Output Rate- 5 Hz. Then you will also have to configure the following in the NAV
These will be the fields you will enter: RawNMEAOutputMaxLLAPrecision - Set to 6
RawNMEAOutputMaxQuality- Set to 2
Also the part number for the harnes was PF90363. Sorry! That is the deere #. | |
|
Trimble GPS to 2630 display
