|
| Problem: In 5.05, in order to draw coverage, the lift switch is required to be in the 'lowered' state, whether actually planting or using Draw Coverage. In Swath Control Only, no lift switch is calibrated. Because of this, the on-screen map will not draw coverage.
In-Field Solution: In RowFlow Setup, under Motor Configuration, select "Lift Switch". Select "Manual Value Entry" and enter the following values: lowered=0, lifted=100, planting=50.
Long Term Solution: This error will be corrected in the next software release.
Note: This error only occurs in version 5.05 software.
| |
|