Near Intersection of I-35 & I-90 Southern Mn. | Here's a cable we use which I call the Raven companion for a Trimble CFX-750. It has Radar out to the Raven speed connector and has loose wires to connect to the Raven Orange/white and White wires. This starts/stops the Coverage map on the CFX-750 based on the Raven Master status.
This harness utilizes a relay to isolate the Raven and CFX-750 although this might not be absolutely necessary. This type of cable is probably available from Trimble but I made these due to demand. I'm sure Ag Express and many other sources could supply them also. With the right connectors, this cable could be made by the end user.
The CFX-750 needs to have the Radar Out enabled and set to about 60 Hz, The Raven speed cal is SP2 and about 600.
The Coverage option on the CFX-750 needs to be set to Switch and Active High for the Coverage map to work properly.
Edited by tedbear 4/29/2011 12:17
(CFX 750 Raven Companion.jpg)
Attachments ---------------- CFX 750 Raven Companion.jpg (42KB - 337 downloads)
|