|
roaming | Then this is normal behavior, because the Planter software detects that no product has been assigned to the Seed layer. The reason it's still mapping ok is because it's mapping the Rawson product (controlled by the Rawson software), but the warning is coming from the Planter software. If you removed the Planter software from the display, the error would go away. Obviously you need the Planter software to control the planter (fold, markers, etc.) so you'll have to work around it.
I think there are two ways you could do this:
1. Simply turn off the Seed Control on the Run Screen. This should prevent the warning, since you're not trying to apply seed via the Planter software.
2. If that doesn't work, just assign a second layer on your Map. This layer will be "Seed", and the Product will be the same as the Product assigned to your Rawson layer.
Edited by torn 4/26/2011 12:38
| |
|