|
Northeast Nebraska | Thanks motram. Maybe you could look to see if there are any D-tachs for me?
I too have the Raven wiring harness, the one with a 16 pin round on one end, and wires with spades on the other end. My control valve is in the "throttling" position, so I shouldn't have to switch any wires around there. If I am reading you post correctly, your regulating valve was in "bypass" meaning, it was regulating how much chemical got returned to the tank. Correct?
Did your section valves have 3 wire weather packs on them? I bought mine from Schaben and they just had bare wires, so I just used butt-splices to connect them.
This is on an 8220, I have a gauge to see pump pressure, so I adjust my hydraulic flow so pump pressure is about 10 psi more than what I need.
I bought weather pack connectors today. Tomorrow I am going to install them on the valves. I am also going to ground the valves through the Ravens wiring harness. I think having the weather-packs will speed trouble shooting if I can hook and unhook them as go through diagnostics. | |
|
Greenstar rate controller - grounding ? - connecting boom valves
