|
Colorado | dewgubbe
I am a little confused.
On page 40-15 of my manual, it talks about calibration of a voltage based sensor and
States pin 26 of 37 is to provide 12v and makes note for a Raven pressure sensor with 12v
power supply but lists no part# for that sensor.
The harness already is wired for a Raven sensor, just wanting to make sure this is the right sensor for the way the harness is wired and get it setup right in the R/C software.
Edited by Radiehl 4/25/2011 00:44
| |
|
GS2 Rate Controller pressure transducer
