Near Intersection of I-35 & I-90 Southern Mn. | tanorm - 4/23/2011 07:32
Dealer had a pig tail that plugged into the back of the EZ 500, had 4 labeled plugs one was implement switch. He couldn't make that work, so said I really didn't need one. We did talk about turning the master switch off when driving where not planted with the planter up. That sounds like a mistake waiting to happen, so I'd like to have an implement switch. So your saying I need to put jumper wires on one of the plugs on the back of the EZ boom is the only way to put a implement switch on it? Thanks in advance.
Yes, put a jumper wire between pins 11 & 14 of the 14 Pin connector. Run a wire from Pin 12 out to the implement switch and another wire back from the implement switch to Pin 13. The Implement switch needs to complete the circuit when the planter is down and the mapping will then stop when the planter is raised. |
EZ Guide 500 EZ Boom
