Near Intersection of I-35 & I-90 Southern Mn. | This can most certainly be done.
Your picture shows a Raven Flowmeter and a Raven control valve along with TeeJet On/Off valves.
The Deere Rate controller typically terminates in a 37 Pin connector which for the most part follows Raven's wiring pattern. I believe there is an adapter available from Deere to change the 37 pin connector to a 16 pin Amp connector which you probably have. This would be the easiest solution.
The worst case scenario might involve some rewiring but even that would not be very complex. This Spring I have made at least 20 wiring harnesses to go from Deere Rate controllers to Raven components like you have. We use Banjo On/Off valves but otherwise these situations would be identical.
Many of these will be going on corn planters for starter fertilizer, some for Accu-flow NH3 and some for sprayers. On planters the On/Off valves are often remotely mouted on the wings with the control valve and flowmeter in the center. The only difference with these is that the boom On/Off wires need to be longer to reach out to the wings.
Your dealer is not working very hard for you. |
JD rate controller won't work on my sprayer says salesman??
