Illustration 4	g00635502
Front view

(8) Dimension from the centerline of the crankshaft bearing bore to the top of the cylinder block

New ... 425.45 ± 0.15 mm (16.750 ± 0.006 inch)

Minimum ... 425.02 mm (16.733 inch)

Note: The total flatness of the top contact surface of the cylinder block must be within 0.10 mm (0.004 inch). The flatness must also be within 0.05 mm (0.002 inch) for any 177.5 mm (6.99 inch) section of the surface.

(9) Bore in the cylinder block for the main bearings

(10) Main bearing cap

Main bearing cap width ... 215.900 ± 0.025 mm (8.5000 ± 0.0010 inch)

Width of the cylinder block for the main bearing cap ... 215.900 ± 0.013 mm (8.5000 ± 0.0005 inch)

(11) New dimension from the centerline of the crankshaft bearing bore to the bottom of the cylinder block pan rails ... 165.10 ± 0.10 mm (6.500 ± 0.004 inch)

(12) Main bearing cap bolts

View Image
Illustration 5	g00562863
Torque-turn tightening method for main bearing cap bolts

Use the following procedure in order to tighten the main bearing cap bolts:

 

1. Apply clean engine oil to the threads of the bolts.

 

1. Tighten the bolts first on the bearing tab side (1) of the cap.

   Torque for bolts ... 260 ± 14 N·m (190 ± 10 lb ft)

 

1. Tighten the bolts on the opposite side (2) .

   Torque for bolts ... 260 ± 14 N·m (190 ± 10 lb ft)

 

1. Put a mark on each bolt and each cap.

 

1. Tighten the bolts on the opposite side (3) from the mark to angle (A) .

   Angle (A) ... 120 ± 5 degrees (2 flats)

 

1. Tighten the bolts on the bearing tab side (4) of the cap from the mark to the following value.

   Angle (A) ... 120 ± 5 degrees (2 flats)

View Image
Illustration 6	g00285129
Right side view

(13) Pipe plug

Apply 5P-3413 Pipe Sealant on the threads of the pipe plugs before installation in the cylinder block.

(14) Piston cooling jet

To prevent damage to the piston cooling jets during service, the piston cooling jets must be removed.

Tighten the bolts that hold the piston cooling jets to the following torque. ... 40 ± 8 N·m (30 ± 6 lb ft)

Minimum permissible clearance between the piston, the piston cooling jet, and the crankshaft ... 0.63 mm (0.025 inch)