|
| We have a customer that is using an EZ-Guide 500 with an EZ-Steer. He does have the orginal version of firmware on the lightbar, so that has not been updated yet. He has a 36'drill and his implement is set to 36'in the lightbar, at least that is what he is telling me. He went into his field and set his AB line, when he turned around to engage on the line there was no line to engage on. The line shifted over an extra 36' so he shifted his line over to where he needed to, he has his ez-steer engaged all the way down the line and when he turned around again, the line shifted over an extra 36' again. I am sending him the new firmware tonight, but has anybody else seen this problem, is it a firmware issue, does he not have the implement set correctly or is something wrong with the lightbar. Thanks in advance. | |
|
EZ-Guide 500 questions again
