|
SE IL | I am not a dealer so I don't know for sure but--I have a 2010 1990 seeder with Seedstar 2 and half width disconnect. Swath control operates these clutches w/o a separate rate controller. I would assume that this setup would be the same. He would need something else to control row clutches however. I am not familiar with how it is done w/ row command but I use a GS rate controller w/ tru counts on my 06 1770. I would think that the hyd motors need to be configured (not necessarily calibrated) before the controller is going to recognize the half width. One other thought-might the fold control box need updated as well? At the very least it may need to be plugged in so that the system can see the half width capability? Thinking out loud here. | |
|
SeedStar 2 OM
