|
ecmn | you will need to make a tool, nothing hard to do, if you have an old heavy duty adjustable wrench you might be able to trim it narrow enough to fit.
we took some 1/2" flat stock and cut a tight 5/8 notch in it, then welded a solid 1" about a foot or so long handle. when you lift the panel under the seat you will see the pump. on the shaft there is a flat spot, that is where the tool goes. make sure you tool fits tight on that flat spot. then you take a hammer and beat it loose. standard thread so you hit the handle down.
1. remove seat and lift access panel.
2. on the big shield around the rear pulley there is 3 bolts, remove them 1 from the cab and the other two you can get from the ground.
3. take your homemade wrench, and losen pump shaft.
4. remove pump from bracket.
5. you should be able to sneak off belt and new one on.
6. move your engagement handle and you will see the linkage where you adjust the tension on the new belt.
set your adjustment. and reverse all steps.
if you have a second hand to help you its not a bad idea. in the shop this would be about a 1 hour ticket. | |
|
7720 - separator drive belt change
