|
| Are you running any restrictors in the baler? If you are, remove them. If not, eject the bale and make sure your bale chamber is clean. Higher hydraulic pressure does not necessarily make a heavier bale as that is largely determined by plunger load, but a low hydraulic pressure may indicate that there is something inside the chamber leading to excessive resistance on the bale. Alternatively there could be excessive resistance on the plunger, producing an abnormally high plunger loads. Material build up in the plunger rails can do this. That being said, 1500 psi for 15% moisture is just about right for a 3x4, I'm not sure about a 4x4.
Edited by Maxzillian 9/9/2010 23:54
| |
|
Massey Fergusson 2190 Baler Problem
