justamerefarmer - propane cylinders should be retested every 10 years. there must be a stamp on the tank. I would think the bulk storage have the same regulations ... This gets into details and nit picking. DOT tanks can't be refilled until they are recertified if it is more than 12 years after manufacture date and every 5 years after that (I think that is current, that's what it was a few years ago when I was doing it). ASME tanks do not have to be recertified, but ARE required to have a legible data plate.So what is the difference? A DOT tank is a portable container like a BBQ grill tank or a 100 # cylinder. They can be as large as 420 # (about 100 gallons). An ASME tank is one not designed for transporting, a fixed tank like at the house or grain dryer. (I know, there are some ASME tanks used as portables for temporary locations. We won't get side tracked down that rabbit trail.) However I seem to recall some talk a few years ago about dates on the relief valves. I believe on bigger tanks (I forget the size affected, for sake of argument we'll say over 6,000 gallons but I'm sure that is not the exact number) Relief valves have a life and must be replaced within so many years of manufacture. They can go out of date on the shelf and can't be installed. As for locations, many many companies have been very lacking in common sense where tank locating is involved. What most people do not understand is they are not trying to protect you from the tank. They are trying to protect the tank from you! Tanks over 124 gallons have to be at least 10 feet, preferably 25 from a building .... ANY building. They can't be under a high voltage line, have stuff stacked around them, be in a traffic pattern, on and on. It all makes good sense, but often good sense is not involved. If your supplier is balking at filling a tank too close to a building GOOD FOR HIM! Sometimes you have to protect customers from themselves. I saw a 500 gallon tank one time set right up next to a garage with an overhanging ventilated soffit. If the relief valve actuated it would have put vapor right into the attic! One time I raised the lid on a tank to find the line to the house was cemented pvc plastic pipe! And it was installed by a licensed plumber! Here is an example from www.propane101.com The picture of the propane tank below illustrates the dangers of unsafe distances regarding relief valve proximity. The arrow labeled 1 is the propane safety relief valve. Arrow number 2 is a hot water heater. Arrow number 3 is the bed of an RV slide-out. If the relief valve were to fully open, the propane stream would be directly underneath the bed of this RV slide-out. If the relief valve opened and propane came in contact with the hot water heater flame (arrow #3), a dangerous situation would present itself immediately
The problem is propane is so safe people become careless. If tanks blew up every day and were constantly in the news people would be very aware of the risks and demand they be placed safely. But because LP has such a good track record people get careless and lazy. www.propane101.com is a very good site to visit It has lots of very good information
Edited by Mike SE IL 8/16/2010 22:27
|