|
Galahad, Alberta | My brothers own a '85 CR 1280 w/ a cat 3306 motor in it. It currently has 8900 hrs on it. Much of my youth was spent on that tractor. They did the bottom end at 5000 just as preventative maintainence, which was a waste of time, as the bearings were fine. It is currently sitting because the tranny brake needs work, and it could be an very expensive fix. Make sure that you grease the bottom king pin in the center well. On this one, you had to articulate the tractor all the way to one side to expose the grease zirc (otherwise it was hidden and thus missed). Stupid design, when they redid the pins, they drilled a new hole from the side for the zirc to make it easier to grease. Trying to remember everything that we fixed in 19 years. Coolant rad, hyd. rad, water pump, electronic feul seleniod x 2, 3 axel seals, alternator x 2, lots of lights, couple of electical breakers, more batteries than I care to remember, hydraulic pressure senders x 3, air conditioning tubing in front of cab from letting hood down slightly crooked and hitting the lines, door handel x 2, throttle cable, 1 driveline bearing & pillow block,king pins, just about every damn haydraulic line under cab from the block back to the rear end! They ran them through a hole in the frame under the cab, and over time they would rub and wear holes, no matter how we tried to isolate them. Ran it on a pull type combine (JD 9501) for a number of years, which took an awful lot of electrical juice. This contributed to a lot of the alternator, battery, breaker and light problems. Finally put a much larger alternator on the motor and that solved a lot of things. I really liked the cab-great visability, but the climate controls are very poor. If you do buy the machine, make sure you read the manual very closely about how to use the clutch so as to not wear out the tranny brake prematurely. If you are at all confused about it, just post to Jon Hagen or myself. Good luck.
Rosco | |
|