|
Carter Montana | If I remember right 132's will only go to 2HZ on WAAS. Beacon you can go to 10 HZ. I don't know about the Omni. Also, if your running Direct Command make sure to set your Baud rate up or it will still limit your ground speed. it will flash a warning any time you get over a certain speed (10 MPH in my case). I went ahead and set the Bauds at 38 K and the delay at ASAP. The book has good directions on how to do this but it can be confusing at first. Just remember the main port is your lightbar and your NEMA port is the alternate. I think most of it is under Ports A and B in Configuration
If you don't have the book let me know and I'll get more detailed. | |
|
trimble 132 1 Hz?
