|
SC | The different leg is adjustable for height to eliminate wobble on an unlevel floor. The removeable bars are free to lift out so it may or may not work well. They are the ones where the end plates are. Chop saw is mounted on a 4x4 tube that slides in the 5x5 frame and is locked in by one bolt. The sliding support for chow saw material will come out 7' and is very handy. I intended to put a sloping sheet of steel to direct slag to one side but then realized I would end up standing on that side no matter which way I put it so made a flat plate to just keep the slag and scraps off the floor. It also works to throw leftover scraps from the chop saw.
Edited by rowcropper 5/18/2010 06:36
| |
|
New table for welding and cutting
