AgTalk Home
AgTalk Home
Search Forums | Classifieds (35) | Skins | Language
You are logged in as a guest. ( logon | register )

Using stationary TMR
View previous thread :: View next thread
   Forums List -> Stock TalkMessage format
 
olivetroad
Posted 11/19/2026 08:00 (#11806177 - in reply to #11805933)
Subject: RE: Using stationary TMR


Kingdom of Callaway - Fulton, Mo 65251
T-rowe - 11/18/2026 21:41

I looked into this also, but my three phase power is about a mile away. There will also be a lot of hidden cost getting it hooked up Iam sure. I have even found and bid on a few smaller stationary vertical mixers on AuctionTime that usually come out of the big dairies. But most of them use a 2 speed gear box and are geared for mixing silage and other pre-chopped ingredients. A PATZ rep. Told me an electric drive unit will not grind a 5*6 bale.

You will also need a hydraulic pump to run your unload conveyor.

I may pursue this in the future again but right now with cheap hay prices I’m just going back to unrolling with a pick up.




Hi Travis,

I have two farms right close to home that have 3 phase running down the road out front. So thats nice. We also have a grain facility running on 480v where we pay $800.00 a month for peak availability even if we never flip a switch on. 8 months of the year its barely used. Thats 12 miles away, but I could use $800 of electricity before it cost me any more that what im paying now.

Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)