AgTalk Home
AgTalk Home
Search Forums | Classifieds (76) | Skins | Language
You are logged in as a guest. ( logon | register )

cutting steel plate for a table saw throat plate
View previous thread :: View next thread
   Forums List -> AgTalk CafeMessage format
 
SDPat
Posted 11/18/2026 20:52 (#11805895 - in reply to #11805887)
Subject: RE: cutting steel plate for a table saw throat plate


I agree a zero clearance plate will destroy the saw blade. And if you make it to clear the blade well enough then it is not a zero clearance plate. Over the years when I have needed a zero clearance plate, I take a piece of wood, pine, oak, mdf, whatever I may have, and cut it on my band saw, a little too big, then sand it down to fit on a belt sander. It appears that saw has screws to hold the plate in, so I'd countersink where the screws go and screw it down. If you don't want to plane something down to the exact thickness needed maybe you can find some plywood or wood sheeting that is close the thickness you need.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)