I have a .138 thick plate on my table saw. The opening is too wide. I need a zero clearance plate or 2, one for the .09 blades and one for the .125 blades. I purchased 2 plates from a vendor on ETSY. They required some work to fit and they are kind of flimsy. They're made of compressed wood or something. This table saw is a Grizzly G0899 and the way it's made doesn't allow for a ½" make it yourself plate as I've done in the past on other saws. Is there someplace that would make a plate out of steel that thick(or thin depending on you point of view). |