Near Intersection of I-35 & I-90 Southern Mn. | As I recall the very first Spinner/Spreader modules were designed to work with only one product. They have been discontinued and most have disappeared since they have been replaced with the 3 product module (the one in your picture) or a 5 product module.
Yours has 3 ports for working with up to 3 separate bins. In your case you are only using one so the other two are covered with dust plugs.
Setting the fan cal to "0" as Shop Teacher suggests should improve your situation with the fan speed indication. Should you decide to add a spinner speed sensor or a speed sensor and spinner hydraulic PWM control valve, you would use the Auxiliary Port. Adding just the spinner speed sensor would allow you to be aware of the spinner speed which you may want to change manually. Adding a spinner speed sensor and a PWM valve would allow the system to attempt to control the spinner speed for you automatically.
Ag Leader includes a Wizard to help you calibrate the system for different products. Calibrating a granular system is more involved than calibrating a liquid system that uses a flow meter. The reason being that a flow meter is a good indicator of the true flow rate over a rather wide range of flow values. Using a shaft sensor to predict the flow rate of a granular product dpends on many factors such as gate setting, product densisty, flowability and variation from one supplier to the next.
Edited by tedbear 11/10/2026 07:22
|
Agleader direct command
