Near Intersection of I-35 & I-90 Southern Mn. | MF3680 - 11/9/2026 06:55
Good morning. Have a new to me fertilizer spreader with agleader direct command and using a versa display. The spreader does not have a spinner sensor on it. I have gone through the setup multiple times and cannot get the web to move. It keeps giving me an alarm that the spinners are not spinning, but they are. I should add that it is a completely hydraulic driven spreader. I have read manual, Googled, and read this forum and cannot figure it out. Do I have a setup problem or a hardware problem? Any tips greatly appreciated.
I assume your are using the Spinner/Spreader Module. As I recall, there should be 3 choices for the spinner. 1) Do nothing, no spinner sensor, no attempt at control other than manual. The display would not show any spinner speed. You would need to guess if the speed is appropraite for your application 2) Use a spinner speed sensor (which your don't have) and control the speed of the spinners yourself through some manual means. If the spinners are run by PTO then changing the tractor engine RPM would change the PTO speed and the spinner speed. The display would show the spinner speed so you could adjust it yourself. 3) install a PWM hydraulic control valve as well as the spinner speed sensor. You would then be able to enter in the desired spinner speed and the system would attempt to adjust the PWM valve to reach that speed. In this deluxe arrangement, the module would be controlling the bed speed and and the spinner speed.
Sounds to me that you are in situation #1 but the setup is thinking that you are in situation #2. This may be as simple as chanaging the spinner choice in the configuration.
In situations like this, I've found that creating a new configuration from scratch is often useful. The questions may make more sense with the second attempt. |
Agleader direct command
