|
| Recently purchased a 1066 with some butchered wiring.
The wire to the mcv sensor runs up to around the battery box where it then ends with a crimp connector. Except there’s no wire to the other side. There’s another wire down there the has power when I flip the key on. Just wondering if that’s the correct wire to hook up to the mcv sensor.
Also, my fuel gauge doesn’t work. My sending unit has two terminals, one bolt on top with a nut. Currently there is a wire on it that runs directly to the gauge on the right hand terminal(when looking at the front side of gauge). My the second terminal looks similar to a spade connector, it did not have any wire running to it when I took the hoods off.
The gauge currently has no movement at all.
 (image (full).jpg)
 (image (full).jpg)
Attachments
----------------
 image (full).jpg (128KB - 7 downloads)
image (full).jpg (154KB - 4 downloads)
| |
|
IH 1066 Wiring
