|
near Mtl, QC | Anybody have installed the 4 sprinkle kit on a T50 and got this error message after installation?
Did the 2 optional front sprinklers installation, when I booted up the T50 got a firmware update message and did it. I'm not 100% sure, but I think the error code wasn't there at that time.
So, after the firmware update that error message popped. Did tried multiples things:
1) swapped the 2 front sprinkler to see if error message will change to M2 arm, but no, still M1 error message.
2)Bought another new esc composite cable, swapped the cable, error persist.
3)Plugged into another new front sprinkle, no change.
4)Bought another new Front Atomized Sprinkler Power Cable, still the same.
5)Downgrade firmware, still same and reupgraded.
Im out of idea now can it be the board?
And yes checked all connections 2-3 time each at minimum everythings looks brand new, no corrosion or bend pins.
EDIT: Forgot to add, when I boot the T50, the m1 sprinkler do half a second spin (or less) like all the others.
Edited by Charloz24 8/17/2026 20:56
| |
|
M1 Centrifugal Motor Connection Error on T50
