Wisconsin | 71307140 - 8/12/2026 13:41
google slug wrench , then get a piece of 1/2 plate and cut one out . Beat it like it owes you money ...
Make two, and weld them together. put the rod into the drawbar of the biggest tractor you own with the biggest pin you own, and support the piston end with solid hardwood blocks, then use whatever it takes to get the leverage and force to loosen the nut, a few hundred degrees will soften the locktite without damaging anything, it's made to operate close to 200F. |
Hydraulic cylinder? Update and new question
