|
| We're replacing an old raven system with a custom sprayer controll system. Got everything hooked up and tested it. My raven flow meter reads accurate up to about 14gpm and then starts dropping as pressure increases. Then if I adjust up a bit more it just reads 0.
New system is 12v supply and 12v signal wire. Old raven system was 5v for both.
Meter has a tag that says supply voltage is good up to 16vdc . Is this true for signal as well?
Do I need to add a resistor in line to clean up signal? On supply or signal or both?
Flow meter model is
10630171066
Edited by ctenc001 8/6/2026 12:07
| |
|
Ravem flow meter help
