|
| I updated an Edge to the new firmware and really like the ability to have everything in TSIP and did help with some layout issues. The tractor I have is a 8410 and it will drive very well and then all of a sudden get about 2-3 inches off then start weaving as it tries to find the line again. I will find the line again, calm down and work very well, if it stays in that 0-1 in range. JAR I tried your idea of moving the minimum voltage up about 5% higher and it seems to help for a little while then goes back to acting goofy. Maybe I should try 10%? I have been up and down the scale on the line aquisition and steering response. I have even been in the tuning section thinking I could help there. It seems to work for a little bit then start getting off. I really like this system, but right now getting it dialed in seems to be very tough. If I hit on something I will let everybody know. | |
|
8100 OnTrac 2 settings
