|
SE NC | Just place a t with an inline 500-1000 psi relief valve on one leg and a line to the brake on the other.
Then when you engage remote oil flows to tee and down line to brake before popping relief valve and maintaining ~1000 psi then get out and close valve to brake holding pressure and then shut off remote to stop the flow in a circle.
ETA
Or use one like pictured and skip t entirely.
Line one from pressure remote port goes to one lower port.
Ball valve and line to brake goes to other lower port.
Line three goes from upper (tank) port to return tractor remote side.
Disclaimer: I’ve never used this valve but I know the idea works. Only potential issue I see is unless you can access ball valve from inside cab it would require two trips off the tractor.
Set remote, get out, close ball valve, get in and disengage remote, get out and unhook wagon and hoses, get in and load wagon.
Hooking up would be one step regardless.
Edited by Hay Farmer 15 7/11/2026 13:40
| |
|
So I just built this new wagon
