|
NE Indiana | We have used a fast close valve on our NH3 bars for over 15 years and have never had a single issue with them. What problems have you seen with them?
I should have specified in the original post that the NH3 system is not new the rate controller itself is. Our agleader liquid product control module took a crap, and we have slowly been switching everything over to deere so decided to go with a rate controller 3 instead of just replacing the agleader module. Ive messed with the control valve settings in the deere rate controller and have it to where I'm happy with it. It locks onto the target rate within a second or 2 after turning on I just didn't know where to start as the rate controller just had 0's in all the valve settings spots.
Edited by kgbarnett22 6/7/2026 14:43
| |
|
Raven fast close nh3 valve speed calibration for Deere rate controller.
