Fairfield County, Ohio, USA | Lauritsenag - 6/7/2026 09:24
I assume mine has the Kinze seed sensors, but I ordered it from the dealer with all Agleader stuff installed so I could use the 1200 in my combine as well. But with the AgLeader everything has to be unplugged when changing any sensors the monitor will not recognise it on its own. FYI, in 6 years, one seed sensor was replaced the 1st year, and a speed sensor this year. so failure rate is rare.
This means that you're using an Ag Leader/Kinze PMM, with Kinze muxbus sensors. Those are the exact same sensors (and harness) used when the planter ships with a KPM2 or KPM3.
The options here are either Ag Leader/Kinze PMM (Planter Monitor Module) or Ag Leader STMM (Seed Tube Monitoring Module). With a PMM, you *generally* need to unplug everything, and then plug it back in, in order. (There are some exceptions; you can theoretically replace a single sensor and just replace it in the configuration, but I've never had that work.) With STMM, the entire concept of learning sensor position is not a thing -- each sensor has its own connection back to the STMM in the harness.
Edited by aNullValue 6/7/2026 11:52
|
Agleader monitor on Kinze planter?
