Posted 6/7/2026 10:34 (#11667770) Subject: Raven fast close nh3 valve speed calibration for Deere rate controller.
NE Indiana
What would be a good starting point for a raven fast close valve. This is a new Deere rate controller 3 but I assume they would have been similar with the older controllers. It’s asking for. Valve speed, overshoot reduction, dead and, and valve effort. This is a new install and all are currently set at 0
This is my first experience with a Deere rate controller as we have always used Agleader.
Raven fast close nh3 valve speed calibration for Deere rate controller.
