|
Watertown, WI | OK. Probably a long shot, but we will see. Somehow, the datatronic 3 in our DT240A is sending a hold/run or working state status to the Micro-Trak ISOBUS modules. I have to unplug the datatronic 3 from the CAN network on the tractor to get the modules to work. This sucks because I use an ag leader InCommand plugged into the diagnostic port as the UT/TC and pull radar and wheel speed right off the datatronic bus.
I can pull the CAN 2 pins from the datatronic 3, but would prefer not if possible for several reasons (speeds/diagnostics)
What changes the working state output of the datatronic 3? I assume it has to run off something like hitch position, PTO, hydraulics, etc? I have found nothing that works, but figured I would check before I start pulling wires to get planting.
Aaron | |
|
Datatronic 3 ISOBUS
