|
NW Iowa | I made this blower with a fan from a central fill planter to use on my skid steer. It has taken out the seal on the output shaft several times now. I’m speculating that I need to remove and cap the line that comes off the return line and feeds into I believe the motor case? It was originally setup that way for a planter but somehow the motor case is getting pressurized??? Will the motor be okay if I do that? Should I switch the case drain to the top port and instead cap the bottom one??
 (IMG_3833 (full).jpeg)
 (IMG_3831 (full).jpeg)
Attachments
----------------
 IMG_3833 (full).jpeg (142KB - 9 downloads)
IMG_3831 (full).jpeg (128KB - 9 downloads)
| |
|
Help Plumbing a hydraulic motor on my homemade blower
