|
| Hi everybody. In our planter tractor we have a wass only EZ-Guide 500 and EZ-Steer and we have one 80 acre field that on the west is bordered by another field and no trees, same on the north end, but on the east and south ends there are power poles. So what happens is when the tractor is heading east the EZ-Steer works fine. The display is just off a few inches so we just nudge, but when the tractor turns around on the south east end of the field right by the power lines and starts heading west the lightbar on the 500 and the EZ-Steer weave and do s-turns back and forth till about the center of the field then it stops. It also seems worse when the sun is shinning/setting and does not do it much after dark. and it does not do it on the north east end of the field. :(
I though it might be the power lines but it only happens where the two power line sets meet in that corner area it does not happen on the north end where there is only one set of power lines, and no the display is not losing sat signal. :(
Does anybody have any ideas as to why this is going on ?
Thanks :) | |
|
EZ-Steer Problem?
