West-Central IL | Andre86 - 4/18/2026 14:44
Maximum engine load is still at 78%.
How do you know...?
Are you just viewing the screen and assuming it's low on power.
That % gauge is just software.
Has the CNH tech hooked up a service software tool to show you what's actually going on. I would not be chasing mechanical solutions to a problem that mighy not exist.
We had a combine once that never read full power in that % gauge.
Ecu was programmed with the wrong engine type from the factory!
It thought it had a bigger motor in it. Took a few higher up calls to allow the dealer to change that as it was tied to the Vin # |
Case IH 7120 only gets up to 80% engine load
