|
Cedar Rapids, Iowa | I have a RTK-enabled Vector Pro mounted on my side-by-side right now connected to a Incommand 1200 for mapping field boundaries.
You can configure the Vector Pro while still connected to the Pro 1200 in the tractor - set it to output NMEA data on COM1 or COM2. Set the baud rate too, 38400 bps or higher. I think the SteadySteer wants GGA and VTG at 10 Hz.
The connector on the Vector Pro is a common 12 pin Deutsch. Pinout is in the link posted by swenzel. | |
|
Incommand 1200, steady steer and vector pro receiver
