|
Southwestern PA | Does anyone have any pictures they can share of their set up with a wet boom and the Hypro X Tender nozzles? I have the Hypro express wet boom ends and teejet 3 way nozzle bodies. I’d like to put the Hypro X Tenders on the outside of my boom(60/80) to make it 60/90 without adding steel. I have been looking at the 3 way nozzle bodies that have the extra qj mounted on the nozzle body frame. However it looks like the Hypro X Tender needs to be mounted 90° horizontally facing the outside end of the boom or mounted at a certain angle to change the additional width of the spray pattern. I also am curious if the additional spray volume of the Hypro X Tenders would mess up the rate controller since the pressure would drop on the two outside wet booms. Or would it? If I changed the width in the raven viper to increase the added boom width of the outside sections it would increase the total volume to those sections but does that mean that the other nozzles on the outside sections would be over pressurized? I’m probably overthinking that part. The problem is that the 90° quick jet cap faces backwards and not sideways. I have found pipethread qj caps and elbows to make them any direction I want, but then I still have the issue of not having adjustable angle to keep them from spraying the maximum 14’ pattern, where I’m just looking for 5’ on each side. If you think I’m making this more complicated than it should be, I probably am! I would love to see your setup. There’s a lot of talented people here and I’m not one of them. Thanks for reading this!! | |
|
Hypro X Tender- boom nozzle mounting on wet boom
