|
NW IL | A few things to try:
- turn NMEA talker “off”
- turn stable loc “off”
- use GGA “legacy” instead of “position”
Years ago I ran a 6500rtk and connected to Deere 2630. From memory: if you turn "NEMA Talker" off the RMC strings were reported as "GPRMC".
GPRMC = GPS only
GNRMC = GLONASS + GPS
Deere prefers GPRMC
Also: I assume you are pulling gps directly out of the 7500 and not via steercommand/steercommandz2 NMEA out?
For the geosteer that you ran in the past, you would have pulled NMEA out of the Geosteer controller. If you are using steercommand or steercommand z2 you can still do this , however the place to change settings is different than what you have pictured.
Edited by swenzel 4/1/2026 06:59
| |
|
Ag Leader 7500 RTK into JD 2630
