|
Jeffersonville, OH | No idea on the ATU300, seen a lot of Trimble and a few Topcon in them.
Essentially, you'd have to come up with a hub to fit the splines of the steering shaft, which I have bought an extra steering wheel and then cut the hub from the center to fashion an adapter for the steering wheel turner, then you need some sort of anti-rotation bracket. Most SxS I've seen just have a straight shaft, or maybe a tilt wheel, but usually like a 2" pipe, and I've taken an muffler clamp, and a heim joint/rod end to make an anti-rotation bracket and pin.
Looking at the Deere, not sure if there are different hubs available, or if Deere used the same one forever so they all match a Deere? Could still possibly take that one apart, and cut the hub out, and weld in a different one if needed?
Chris | |
|
Auto Steer Side by Side
