|
SW Iowa | If you have a charger that works (?) you may be able to open up packs and replace cells (either all of them, or the ones that test bad).
Is there any chance your battery packs use same connection as Makita? It's probably a long shot but searching online one of the batteries that showed up said Makita on the side...
I would guess you could do some butchery and epoxy the input side of a generic M18 adapter to your Uponor tool if you were so inclined. In that case you then need to decide whether you want to chance the motor etc surviving ok at the higher voltage or if you need something with a dc-dc converter to step down to 14.4. | |
|
Uponor Pex Expansion Tool
