Posted 2/5/2026 08:47 (#11540590 - in reply to #11539846) Subject: RE: Mueller/Trimble ISO rate controllers- dry spreader application
Arco MN
I do beleive your scaled have to be ISO enabled.
I am not sure if you can add an ISO module to something to make that possible?
It sure is nice for calibrations using this though that is for sure.
My twin tank system takes just a minute to calibrate, just stop, activate the calibrate mode, Make a round or 2 then stop calibration and it does its thing and if it looks good apply it and keep going.
Mueller/Trimble ISO rate controllers- dry spreader application
